The light incubator is a fully automatic microcomputer-controlled system featuring a touch interface for easy operation. It supports programmable multi-segment control, allowing independent setting of temperature, humidity, illumination, and time for both day and night cycles. The unit includes an air duct ventilation system that ensures gentle airflow and even temperature distribution throughout the chamber. The transparent, hollow reflective tempered glass not only enhances thermal insulation but also contributes to a sleek and modern appearance. The fully enclosed, opaque lampshade offers flexibility with optional studio power supplies and built-in disinfection devices.
Light Incubator Instructions:
1. For temperature control settings, please consult the manual provided with the intelligent digital temperature controller. 2. To start the incubator, turn on the main power switch. Once powered on, the indicator light will illuminate, confirming that the system is operational. 3. The incubator is equipped with a break-point protection feature and a 90-second delay function. After the compressor stops, it will take approximately one and a half minutes before it restarts. 4. If lighting is required, simply activate the light switch. The internal lighting system is designed for optimal visibility without affecting the incubation environment.
Common Malfunctions and Solutions:
1. Frequent startups can reduce the overall lifespan of the equipment. 2. In balanced mode, the compressor runs continuously, which improves cooling efficiency and helps maintain the compressor in good condition. 3. Poor air circulation may result from overcrowded items inside the incubator or a malfunctioning internal fan. 4. Prolonged use of the lighting system can cause the bulb to heat up, leading to uneven temperature distribution. 5. Uneven temperature distribution may occur due to improper placement of items or insufficient air flow. 6. When operating in single-mode, the system will activate when the temperature drops below the set point. Opening or closing the door frequently can cause significant temperature fluctuations, potentially overloading the compressor. 7. If the compressor is not cooling properly, the internal temperature may become uneven, or the air outlet might freeze, indicating a possible refrigerant issue or blockage in the ventilation system.
For best performance, ensure regular maintenance and follow the manufacturer's guidelines. Always allow the incubator to stabilize after each use, and avoid overloading the interior with too many items at once. Proper usage and care will significantly extend the life of your light incubator and ensure consistent, reliable results.
Hair Brush,Hair Dryer Brush,Straightening Brush,Hot Air Brush
Zhejiang Hisun Electrical Appliance Co.,Ltd , https://www.cn-hisun.com