Shake table operation procedures

The vibration table must be operated by trained and designated operators, and non-operators are not allowed to perform any operation. In the vibration test, if the control computer crashes, the green button on the signal amplifier should be pressed in time. In the vibration test, if there is a sudden event, it must be stopped. When the software and signal amplifier are stopped, it is not desirable. You can press the red tight stop button on the electrical control cabinet. It is forbidden to install the control software needed for the non-test in the control computer of the vibration table. It is not allowed to open any software in the computer when the control software of the vibration table runs.

If there is a long-term test with a displacement of more than 10mm , check the center of the tabletop every 30 minutes and adjust the air volume of the air valve so that the tabletop is in a static position (the height of the upper plane of the tabletop screw is the same as the center position indication height.) Effect). It is forbidden to touch the sensor during the vibration operation. When the vibration table is working, no magnetic object is allowed to approach the vibration table. A torque wrench must be used for the installation and removal of the vibration table fixture. When the vibration table is operated with automatic control, a closed-loop test with the participation of sensors is required.